OPERATOR’S MANUAL FOR INFANT INCUBATOR EDITION/REVISION B/0
2-1
I4-1
SECTION 2
INSTALLATION
2.1 GENERAL
This section provides installing procedures about Infant Incubator.
2.2 UNPACKING
Generally, the Infant Incubator is usually packed to two cartons: main body and fixed cabinet
or Vertical Height Adjustment cabinet (VHA cabinet). When taking out the equipment from the
cartons, take care not to damage the spare parts of the Infant Incubator.
2.3 INSTALLATION
At least two professionals are required to do the installation of the Infant Incubator with
spanners.
1. Install the main body onto the fixed cabinet or Vertical Height Adjustment cabinet
A. The installation of main body onto the fixed cabinet
a. As figure 2.1 indicates, put on the spring washer, flat washer on the casters, and then
connect with cabinet firmly. Note: The caster with brake must be installed in front of the cabinet.
FIGURE 2.1
b. As figure 2.2 indicates, lock the casters with brake, and put the guard rail and main body
on the cabinet, and then fix them with the lock mechanism on two sides of cabinet.
Main body of Incubator
Guard Rail
Lock
II
Cabinet
I
To Next Page
