30 / 76 ♦ BKI16ATEX0018X ♦ htk4014a0600p_03
4.4 POWER-ON AND START-UP
The MicroTREK 2-wire is pre-configured in accordance to customer order specifications and measurements can be made immediately.
A start-up time of less than 60 seconds should be allowed once the unit is connected and the power is switched on.
If the probe length has been shortened since delivery, please refer to section
3.3.1: Summary of User Functions, user function 1.1.6: Probe length to modify configured probe length.
4.5 AVAILABLE USER INTERFACES
Programming of MicroTREK can be done using the following instruments / accessories:
PCSTAR 2 software Accessory shipped with the instrument.
See chapter „5.1 Programming with PCSTAR 2 software”. (PC needed.)
SAP-300 display unit Can be ordered.
See chapter „5.2. Programming with SAP-300 display unit”.
MultiCONT universal process controller Can be ordered.
For programming instructions see the User Manual of Multicont.
HART® (HHC) Handheld Communicator Sold separately. Automatic device detection on powering.
See chapter „5.3 Programming with HART® (HHC) Communicator”.
To Next Page
Loading...
