Copyright © 2008 Nokia. All rights reserved. 29
Call functions
If the recipient has several SIP addresses in the contact
card, select the SIP address to which you want to send
the invitation, and Select to send the invitation.
If the SIP address of the recipient is not available, enter
a SIP address. Select OK to send the invitation.
3 Sharing begins automatically when the recipient
accepts the invitation.
The loudspeaker is active. You can also use a headset to
continue your voice call while you share live video.
4 Select Pause to pause the sharing session. Select
Continue to resume sharing.
5 To end the sharing session, select Stop. To end the voice
call, press the end key.
Accept an invitation
When someone sends you a share invitation, an invitation
message is displayed showing the sender’s name or SIP
address. If your device is not set to Silent, it rings when
you receive an invitation.
If someone sends you a share invitation and you are not
within UMTS network coverage, you will not know that you
received an invitation.
When you receive an invitation, select Accept to begin the
sharing session, or Reject to decline the invitation. The
sender receives a message that you rejected the invitation.
You can also press the end key to decline the sharing
session and disconnect the voice call.
To end the sharing session, select Stop.
Log
In the log, you can monitor phone calls, text messages,
packet data connections, and fax and data calls registered
by the device.
Connections to your remote mailbox, multimedia
messaging centre, or browser pages are shown as data
calls or packet data connections in the general
communications log.
Note: The actual invoice for calls and services
from your service provider may vary, depending
on network features, rounding off for billing,
taxes, and so forth.
Note: Some timers, including the life timer, may
be reset during service or software upgrades.
Recent calls
The device registers the phone numbers of missed,
received, and dialed calls, and the approximate duration of
your calls. The device registers missed and received calls
only if the network supports these functions, and the
device is switched on and within the network service area.
To view recent calls (network service), select Menu > Log
> Recent calls and a call type.
To Next Page
Loading...
