Nokia 6110 - Navigator Application; Starting the Navigator

32 Copyright © 2008 Nokia. All rights reserved.
Navigator
The Global Positioning System (GPS) is operated by the
government of the United States, which is solely
responsible for its accuracy and maintenance. The
accuracy of location data can be affected by adjustments
to GPS satellites made by the United States government
and is subject to change with the United States
Department of Defense civil GPS policy and the Federal
Radionavigation Plan. Accuracy can also be affected by
poor satellite geometry. Availability and quality of GPS
signals may be affected by your location, buildings, natural
obstacles, and weather conditions. The GPS receiver should
only be used outdoors to allow reception of GPS signals.
Any GPS should not be used for precise location
measurement. and you should never rely solely on location
data from the GPS receiver and cellular radio networks for
positioning or navigation.
Almost all digital cartography is inaccurate and
incomplete to some extent. Never rely solely on the
cartography provided for use in this device.
If your device cannot find the satellite signal, consider the
following:
• If you are indoors, go outdoors to receive a better
signal.
• If you are outdoors, move to a more open space.
• Check that your hand does not cover the GPS antenna
of your device.
• If the weather conditions are bad, in such a case the
signal strength may also be affected.
• Establishing a GPS connection may take several
minutes.
Navigator application
To start the Navigator application, press the Navigator key,
or select Menu > Navigator.
With the Navigator application, you can navigate, search
places and routes, and plan trips. You receive voice
guidance and visual travel instructions with the map
turn-by-turn during your trip.
When you launch the Navigator application, it zooms to
the last known position and displays Getting position
until the GPS receiver is able to calculate your position.
Navigator key
You can use the Navigator key as a shortcut to different
functions depending on the state of the Navigator
application when you press the key.
• If the Navigator application is not running, the
Navigator key starts the application.
• If the Navigator application is on the display but not
showing the current position, the Navigator key moves
the map to current position.