88 Copyright © 2008 Nokia. All rights reserved.
Connectivity
will not make any calls, except to the emergency numbers
programmed into your device, while in this mode. To make
calls from your device, you must first leave the remote SIM
mode. If the device has been locked, enter the lock code to
unlock it first.
Send data
There can be only one active Bluetooth connection at a
time.
1 Open an application where the item you wish to send is
stored.
2 Scroll to the item you want to send, and select Options
> Send > Via Bluetooth.
The device starts to search for devices within range.
Paired devices are shown with .
When searching for devices, some devices may show
only the unique device addresses. To find out the
unique address of your device, enter the code *#2820#
in the standby mode.
If you have searched for devices earlier, a list of the
devices that were found previously is shown first. To
start a new search, select More devices.
3 Select the device with which you want to connect.
4 If the other device requires pairing, enter a passcode
(1-16 digits) and agree with the owner of the other
device to use the same code.
When the connection has been successfully established,
Sending data is displayed.
Data received using Bluetooth connection can be found in
Inbox in Messaging.
Paired devices view
Paired devices are indicated by in the search result list.
In the Bluetooth main view, scroll right to open a list of
paired devices.
Do not accept Bluetooth connections from sources you do
not trust.
To pair with a device, select Options > New paired device.
Select the device with which to pair. Exchange passcodes.
To cancel pairing, scroll to the device whose pairing you
want to cancel and press the clear key. If you want to
cancel all pairings, select Options > Delete all.
To set a device to be authorized ( ) and automatically
allow connections between your phone and the device
without accepting the connection, scroll to the device, and
select Options > Set as authorised. Use this status only
for devices you own or devices that belong to someone you
trust. To disallow automatic connections, select Set as
unauthorised.
To Next Page
Loading...
