80 Copyright © 2008 Nokia. All rights reserved.
Settings
service provider when you subscribe to the service (Set by
network).
Call waiting (network service) — to set the network to
notify you of a new incoming call while you have a call in
progress. To request the network to activate call waiting,
select Activate. To request the network to deactivate call
waiting, select Cancel. To check whether the function is
active, select Check status.
Reject call with SMS — to enable rejecting phone calls
with a text message. See "Answer or reject a call", p. 25.
Message text — to enter a text to be sent when you reject
a call with a text message
Image in video call — to select a still image to be shown
instead of the video when you deny video sending in a
video call
Automatic redial — to set the device to make a maximum
of 10 attempts to connect the call after an unsuccessful
call attempt. Press the end key to stop automatic redialing.
Summary after call — to set the device to briefly display
the approximate duration of the last call
Show call duration — to set the device to display the call
duration during a call
Speed dialling > On — to set the device to dial the
numbers assigned to the speed dialing keys, 2 to 9, by
pressing and holding the corresponding number key
Anykey answer > On — to answer an incoming call by
briefly pressing any key, except the left and right selection
keys, volume keys, my own key, Navigator key and the end
key
Line in use (network service) — shown only if the SIM card
supports two subscriber numbers, that is, two phone lines.
Select which phone line (Line 1 or Line 2) you want to use
for making calls and sending short messages.
Calls on both lines can be answered irrespective of the
selected line. You cannot make calls if you select Line 2
and have not subscribed to this network service. To prevent
line selection, select Line change > Disable if supported by
your SIM card. To change this setting, you need the PIN2
code.
Call divert
Call divert is a network service.
1 Select which calls you want to divert: Voice calls, Data
and video calls, or Fax calls.
2 Select the desired option. For example, to divert voice
calls when your number is busy or when you reject an
incoming call, select If busy.
3 To set the divert option on or off, select Activate or
Cancel. To check whether the option is activated, select
Check status. Several divert options can be active at
the same time.
To Next Page
Loading...
