Menu functions
30 Copyright © 2004 Nokia. All rights reserved
Call counters and call timers
Note: The actual invoice for calls and
services from your service provider
may vary, depending upon network
features, rounding-off for billing,
taxes and so forth.
Press Menu and select Call register. Select
• Call duration and scroll to view the
approximate duration of your incoming
and outgoing calls in hours, minutes and
seconds. To clear the timers, the security
code is needed.
Each phone line has its own call timers
and the timers of the selected line is
displayed. See ”Line for outgoing calls” on
page 32.
• Call costs (network service) and select Last
call units or All calls' units to check the
cost of your last call or all calls.
Select Call cost settings and then select
Clear counters, or select Show costs in to
set the phone to show the remaining talk
time in terms of charging units Units, or
units of currency, Currency. Contact your
service provider for charging unit prices.
Select Call cost limit to limit the cost of
your calls to a certain amount of charging
units or units of currency. The PIN2 code is
needed for the call cost settings.
Note: When no more charging units
or currency units are left, calls may
only be possible to the emergency
number programmed into your
phone (e.g. 112 or other official
emergency number).
• GPRS data counter and scroll to check the
amounts of data that were last sent and
last received, data sent and received in
total, and to clear the counters. The
counter unit is a byte.
• GPRS connection timer and scroll to check
the duration of the last GPRS connection
or the total GPRS connection. You can also
clear the timers.
■ Profiles
(Menu 3)
Your phone has various setting groups, or
profiles, for which you can customise the
phone tones for different events and
environments. At first, personalise the profiles
to your liking and then you only need to
activate a profile to use it.
Available profiles are General, Silent,
Meeting, Outdoor, and Pager.
Press Menu and select Profiles. Scroll to a
profile and press Select.
• To activate the profile, select Activate.
Tip: To change the profile quickly in
standby mode, press the power key
, scroll to the profile you want to
activate and press Select.
• To set the profile to be active for a certain
amount of time up to 24 hours, select
Timed and set the time. When the time set
for the profile expires, the previous profile
that was not timed, becomes active.
• To personalise the profile, select
Personalise. Select the setting you want to
change and make the changes.
The settings can also be changed in the
Tone settings menu, see ”Tone settings” on
page 33. In addition, you can rename a
profile, Profile name. The General profile
cannot be renamed.
■ Settings (Menu 4)
Alarm clock
The alarm clock uses the time format set for
the clock. The alarm clock works even when
the phone is switched off.
To Next Page
Loading...
