Menu functions
42 Copyright © 2004 Nokia. All rights reserved
To stop the countdown timer or to change
the countdown time:
Press Menu, select Extras and Countdown
timer. Select Change time to set the timer
again, or Stop timer to stop the timer.
Stopwatch
You can measure time, take intermediate
times or lap times by using the stopwatch.
During timing, the other functions of the
phone can be used.
Using the stopwatch consumes the battery
and the phone's operating time will be
reduced. Be careful not to let it run in the
background when performing other
operations with your phone.
Time observation and time splitting
1. Press Menu, select Extras, Stopwatch and
Split timing.
You can select Continue if the timing was
set in the background, for example,
because of an incoming call.
2. Press Start to start the time observation.
Press Split every time you want to take an
intermediate time. The intermediate times
are listed below the running time on the
display. Scroll to view the times.
3. Press Stop to stop the time observation.
4. Press Options and select
Start to start the time observation again.
The new time is added to the previous
time.
Save to save the time. Key in a name for
the measured time and press OK. If no
name is keyed in, the total time is used as
a title.
Reset to reset the time without saving it.
Lap times
Press Menu, select Extras, Stopwatch and
Lap timing. Press Start to start the time
observation and Lap to take a lap time. Press
Stop to stop the lap timing. Press Options
and you can save or reset the lap times. Refer
to ”Time observation and time splitting”
above.
Viewing and erasing times
Press Menu, select Extras, and Stopwatch.
If the stopwatch is not reset, you can select
Show last to view the latest measured
time.Select View times. and a list of names or
final times of the time sets is shown, select
the time set you want to view.
To delete the saved times, press Options and
select Erase times. Select All at once and press
OK, or select One by one and scroll to the
times you want to delete. Press Erase and
press OK.
■ Mobile Internet
services, WAP
(Menu 12)
See also ”WAP (Wireless Application
Protocol)” on page 9.
Note: The phone must be switched
on to use this function. Do not
switch on the phone when the use of
wireless phone is prohibited or when
it may cause interference or danger.
The WAP services use Wireless Mark-Up
Language (WML) on their WAP pages. Web
pages using the Hyper Text Mark-Up
Language (HTML) cannot be viewed on your
phone.
Basic steps for accessing and using
WAP services
1. Save the service settings that are needed
to access the WAP service that you want
to use. See ”Setting up the phone for a
WAP service” below and ”Appearance
settings of the WAP browser” on page 46.
To Next Page
Loading...
