Menu functions
Copyright © 2004 Nokia. All rights reserved 33
Press Menu, select Settings, Phone settings
and Network selection. Select Automatic and
the phone automatically selects one of the
cellular networks available in your area.
If you select Manual, the phone shows a list
of the available networks and you can select a
network that has a roaming agreement with
your home network operator. Otherwise, No
access will be displayed and you must select
another network. The phone stays in manual
mode until the automatic mode is selected or
another SIM card is inserted into the phone.
Confirm SIM service actions
See ”SIM services (Menu 13)” on page 49.
Help text activation
To set the phone to show or not to show the
help texts, press Menu, select Settings, Phone
settings and Help text activation.
See also ”Using the menu” on page 25.
Start-up tone
To set the phone to play or not to play a start-
up tone when the phone is switched on, press
Menu, select Settings, Phone settings and
Start-up tone.
If you have set a welcome note, the start-up
tone will not be played, see ”Welcome note”
on page 32.
Tone settings
Press Menu, select Settings and then Tone
settings. You can find the same settings in the
Profiles menu, see ”Profiles (Menu 3)” on page
30.
Select Incoming call alert to choose how the
phone notifies you of an incoming voice call.
The options are Ringing, Ascending, Ring
once, Beep once and Off.
Select Ringing tone, Ringing volume and
Vibrating alert for an incoming voice call and
an incoming message. The vibrating alert does
not work when the phone is connected to a
charger, desktop stand, or a car kit.
Tip: If you receive a ringing tone via
IR or OTA, you can save ten ringing
tones at a time in the ringing tone
list.
Select Message alert tone to set the alert tone
for the incoming messages, Keypad tones, or
Warning tones to set the phone to sound
tones, for example, when the battery is
running out of power.
Select Alert for to set the phone to ring only
upon calls from phone numbers that belong
to a selected caller group. Scroll to the caller
group you want or All calls and press Mark.
Accessory settings
The accessory settings menu is shown only if
the phone is or has been connected to one of
the following accessories, headset HDC-9P or
complete handsfree car kit CARK-91.
Press Menu, select Settings and Accessory
settings. Select Headset, Handsfree or
Loopset.
• Select Default profile to select the profile
you want to be automatically activated
when you connect the selected accessory.
You can select another profile while the
accessory is connected.
• Select Automatic answer to set the phone
to automatically answer an incoming call
after five seconds. If the Incoming call
alert is set to Beep once or Off, automatic
answer will not be in use.
• Select Lights to set the lights permanently
on, On. Select Automatic to set the lights
on for 15 seconds after a keypress. The
Lights option is available only when
Handsfree is selected.
• Select Use loopset to set the loopset in use
instead of the headset,
To Next Page
Loading...
