7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Boot Options
Edition: 01 3HE 16132 AAAB TQZZA 197
Description This command configures the IP address used for a ping-test after the system boots.
The no form of this command removes the ping-address configuration. Setting a value of 0
also removes the ping-address configuration.
Parameters ip-address — Specifies an IPv4 IP address in the form a.b.c.d, for example, 10.1.2.10.
uplinkA-address
Syntax uplinkA-address ip-address/mask
no uplinkA-address
Context bof
Supported
Platforms
7210 SAS-M (network mode and access-uplink mode), 7210 SAS-Mxp, 7210 SAS-Sx/S 1/
10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-T (network mode and access-uplink mode)
Description This command configures the uplinkA address.
The no form of this command sets the uplinkA to use DHCP to get the IP and the show bof
value reflects 0 for this parameter.
Parameters ip-address — Specifies the IP address of the BOF. This address must be unique within
the subnet and specified in dotted decimal notation.
Values a.b.c.d
mask — Specifies the subnet mask length when the IP prefix is specified in CIDR
notation. When the IP prefix is specified in CIDR notation, a forward slash (/)
separates the ip-addr from the mask-length parameter. The mask length parameter
indicates the number of bits used for the network portion of the IP address; the
remainder of the IP address is used to determine the host portion of the IP address.
Values 1 to 30
uplinkB-address
Syntax uplinkB-address ip-address/mask
no uplinkB-address
Context bof
Supported
Platforms
7210 SAS-M (network mode and access-uplink mode), 7210 SAS-Mxp, 7210 SAS-Sx/S 1/
10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-T (network mode and access-uplink mode)
Description This command configures the uplink-B address.
The no form of this command sets the uplinkB to use DHCP to get the IP and the show bof
value reflects 0 for this parameter.