System Management
520
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
The no form of this command specifies that software does not allocate any resources for use
by the SAP egress aggregate policer. If no resources are allocated for use, the software fails
all attempts to enable the configuration of the sap-aggregate-meter command for a SAP.
Default no egress-sap-aggregate-meter
Parameters num-resources — Specifies the maximum amount of resources for use by this filter
match criteria.
Values 0 to 2
Default 0
ipv6-128bit-match-enable
Syntax [no] ipv6-128bit-match-enable num-resources
Context configure>system>resource-profile>egress-internal-tcam>acl-sap-egress
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command allocates maximum resources for use by egress filter policies using ipv6
criteria with 128-bit IPv6 addresses.
The resources cannot be shared with any other egress filter policies that specify other match
criteria. Refer to the 7210 SAS-M, T, R6, R12, Mxp, Sx, S Router Configuration Guide for
more information on resource allocation and fields available for use.
The no form of this command specifies that the software does not allocate any resources for
use by egress filter policies using ipv6 criteria with 128-bit IPv6 addresses. If no resources
are allocated for use, the software fails all attempts to associate a service entity (for example,
SAP and IP interface) with a filter policy using this match criteria.
Default no ipv6-128bit-match-enable
Parameters num-resources — Specifies the maximum amount of resources for use by this filter
match criteria. A minimum value of 2 (indicating two chunks of resources) must be
allocated to use this match-criteria. If not, association of a policy with ipv6-128bit
criteria to a SAP will fail. It is mutually exclusive to use of SAP egress aggregate
meter.
Values Table 45 lists the parameter values.
Table 45 Number of Resources Available for IPv6-128Bit-Match-Enable
Platforms Min value
(per node)
Max value
(per node)
Default
Values
7210 SAS-M (per node) 0 2 0