Nokia 7210 SAS-M User Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 537
The available resources are used by software to allocate policers for SAPs whose ingress
policy uses the IP DSCP table-based classification policy. The users need to allocate
resources from the ingress internal TCAM pool before DSCP classification can be used. This
means users need to take away resources from other features such as mac-match criteria
from the SAP ingress classification or ACL ingress to allocate resources for DSCP
classification.
Refer to the 7210 SAS-M, T, Mxp, Sx, S Quality of Service Guide for more information on
resource allocation and fields available for use.
The no form of this command does not allocate any resources for use by SAP ingress QoS
policies using a DSCP table-based classification policy. If no resources are allocated for use,
the software fails all attempts to associate a service entity (for example, SAP and IP interface)
with a SAP ingress QoS policy using the DSCP table-based classification policy.
Parameters num-resources — Specifies the maximum amount of resources (slices) for use by the
DSCP table-based classification policy. Each slice has a fixed number of entries.
DSCP table-based classification requires exclusive use of the allocated resources.
If the user specifies max, the software allocates one chunk when the first SAP is
associated with an ingress filter policy using this match criteria. It continues to
allocate resources to SAPs associated with an ingress filter policy using this criteria,
provided that the total amount of resources allocated does not exceed the resources
allocated to qos-sap-ingress-qos resource pool (configured with the config system
resource-profile ingress-internal-tcam qos-sap-ingress-resource command)
and chunks are available for use.
Values 0 to 10, max (7210 SAS-Mxp)
0 to 12, max (7210 SAS-R6 and 7210 SAS-R12)
Default 0
ipv4-mac-match-enable
Syntax ipv4-mac-match-enable num-resources
no ipv4-mac-match-enable
Context configure>system>resource-profile>ingress-internal-tcam>qos-sap-ingress-resource
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command allocates maximum resources for use by SAP ingress QoS policies using both
MAC (any) and IPv4 criteria (any) criteria in a policy.
The available resources is used by software to allocate resources for SAP ingress policies
using the following criteria - either both IPv4 criteria any and MAC criteria any, only mac
criteria any, only ipv4 criteria, dot1p-only criteria, ipv4 dscp-only criteria and ipv6 dscp-only
criteria. It is not used for SAP ingress policies that use ipv6 criteria any.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English