Nokia 7210 SAS-M - Page 536

System Management
536
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
Note:
1. The maximum value is 9 if acl-sap-ingress is configured as 9.
ip-dscp-port-if-match-enable
Syntax ip-dscp-port-if-match-enable num-resources
no ip-dscp-port-if-match-enable
Context configure>system>resource-profile>ingress-internal-tcam>qos-sap-ingress-resource
Supported
Platforms
7210 SAS-Mxp, 7210 SAS-R6 and 7210 SAS-R12.
Description This command allocates resources for use by SAP ingress QoS policies that use IP DSCP
table-based classification.
Table 51 Number of Resources Available for IPv4-IPv6-128-Match-Enable
Platforms Min value
(per node)
Max value
(per node)
Default
Values
7210 SAS-M (per node) 0 5 0
7210 SAS-T access-uplink mode (per node) 0 7 3
7210 SAS-T Network Mode (per node) 0 6 3
7210 SAS-R6 (per IMMv1) 0 (per IMM) 5 max
7210 SAS-R6 and 7210 SAS-R12 (per
IMMv2)
0 (per IMM) 7 max
7210 SAS-R6 and 7210 SAS-R12 (per IMM-c) 0 (per IMM)
7
1
max
7210 SAS-Mxp (per node) 0 10 max
7210 SAS-Sx 1/10GE (per node) (standalone) 0 6 max
7210 SAS-Sx 1/10GE (standalone-VC) 0 5 max
7210 SAS-S 1/10GE (per node) (standalone) 0 6 max
7210 SAS-S 1/10GE (standalone-VC) 0 5 max
7210 SAS-Sx 10/100GE (per node) 0 4 max