System Management
548
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
• ingress and Egress MIPs on SAPs and SDP Bindings and some entries are used for
system internal use
The no form of this command is not supported. At least a single slice must be allocated for
use with Down MEP, as some of the resources are reserved for system internal use. The
software enforces it and errors out an attempt to change it to a value less than 1.
Parameters num-resources — Specifies the maximum amount of resources for use by down-mep.
Values 1 to 3
Default 1
sap-down-mep
Syntax sap-down-mep num-resources
no sap-down-mep
Context configure>system>resource-profile>ingress-internal-tcam>eth-cfm
Supported
Platforms
7210 SAS-Sx/S 1/10GE: standalone-VC
Description This command configures resources for CFM/Y.1731 down MEPs on SAPs.
The no form of this command removes resources for down MEPs on SAPs.
Default 1
Parameters num-resources — Specifies the maximum amount of resources for use by down MEPs
on SAPs.
Values 1
sdp-down-mep-ing-mip
Syntax sdp-down-mep-ing-mip num-resources
no sdp-down-mep-ing-mip
Context configure>system>resource-profile>ingress-internal-tcam>eth-cfm
Supported
Platforms
7210 SAS-Sx/S 1/10GE: standalone-VC
Note: This is a per IMM resource for 7210 SAS-R6 and 7210 SAS-R12 feature. For SAPs,
resources are needed only on the IMM where the SAP is allocated. For SDPs, resources
are needed on all the IMMs, as a MPLS packet could potentially be received on any network
port.
To Next Page
Loading...
Need help?
General
