Nokia 7210 SAS-M User Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 549
Description This command configures resources for CFM/Y.1731 down MEPs on SDPs and ingress
MIPs.
The no form of this command removes resources for down MEPs on SDPs and ingress MIPs.
Default 1
Parameters num-resources — Specifies the maximum amount of resources for use by down MEPs
on SDPs and ingress MIPs.
Values 1 to 2
up-mep
Syntax up-mep num-resources
no up-mep
Context configure>system>resource-profile>ingress-internal-tcam>eth-cfm
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command enables the context to allocate resources for CFM UP MEPs.
Resources for UP MEPs created on SAP and SDP Bindings are allocated from this pool.
The no form of this command specifies that the software does not allocate any resources for
use by CFM UP MEPs. If no resources are allocated for use, the software fails all attempts to
configure an UP MEP.
Default 0
Parameters num-resources — Specifies the maximum amount of resources for use by CFM UP
MEPs.
Values 0 to 2 (7210 SAS-R6, 7210 SAS-R12, 7210 SAS-Sx/S 1/10GE:
standalone and standalone-VC, 7210 SAS-Sx 10/100GE,
7210 SAS-Mxp)
0 to 1 (7210 SAS-M and 7210 SAS-T)
Note:
• On the 7210 SAS-R6 and 7210 SAS-R12, when a UP MEP on a SDP Binding is
created resources are allocated for the UP MEP on all the IMMs and when a UP MEP
on a SAP is created resources are allocated only on the IMM where the SAP is
configured or on the set of IMMS if the SAP is configured over a LAG.
• On the 7210 SAS-R6 and 7210 SAS-R12, resources from this pool are used only for
UP MEPs configured in Epipe services. UP MEPs configured in a VPLS service use
resources from a different pool.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English