Nokia 7210 SAS-M User Manual

System Management
550
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
ipv6-ipv4-match-enable
Syntax ipv6-ipv4-match-enable num-resources
no ipv6-ipv4-match-enable
Context configure>system>resource-profile>ingress-internal-tcam>qos-sap-ingress-resource
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command allocates resources from the SAP ingress QoS resource pool for ipv6-criteria.
Users need to use this command before using IPv6 criteria SAP ingress QoS policies.
These resources can be shared with SAP ingress policies that use IPv4 criteria.
Refer to the 7210 SAS-M, T, R6, R12, Mxp, Sx, S Router Configuration Guide for more
information about the resource allocation for ingress filter policy and fields available for use
with ingress filter policy.
Refer to the 7210 SAS-M, T, Mxp, Sx, S Quality of Service Guide for more information about
the resource allocation for SAP ingress QoS policy.
The no form of this command specifies that the software does not allocate any resources for
use by ingress SAP QoS policies using IPv6 criteria. If no resources are allocated for use, the
software fails all attempts to associate a service entity (for example, SAP and IP interface)
with an ingress filter policy using this match criteria.
Parameters num-resources — Specifies the maximum amount of resources for use by this SAP
ingress Qos policy match criteria.
If the user specifies max, the software allocates one chunk when the first SAP is
associated with a SAP ingress QoS policy using this match criteria. It continues to
allocate resources to SAPs associated with SAP ingress QoS policy using this
criteria, as long as the total amount of resources allocated does not exceed the
resources allocated to SAP ingress QoS policies (configured with the command
config system resource-profile ingress-internal-tcam qos-sap-ingress-
resource command) and chunks are available for use.
Values Table 59 lists the parameter values.
Table 59 Number of Resources Available for IPv6-IPv4-Match-Enable
Platforms Min value
(per node)
Max value
(per node)
Default
Values
7210 SAS-M (per node) 0 10 0
7210 SAS-T Access-Uplink mode (per node) 0 7 0
7210 SAS-T Network Mode (per node) 0 6 0
7210 SAS-R6 (per IMMv1) 0 7 max

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English