Nokia 7210 SAS-M - Page 555

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 555
qos-sap-egress-resource
Syntax qos-sap-egress-resource num-resources
no qos-sap-egress-resource
Context config>system>res-prof>ing-internal-tcam
Supported
Platforms
7210 SAS-R6 and 7210 SAS-R12 (only supported on IMMv1 and IMMv2 cards, it is not
supported on IMM-c cards)
Description This command configures resource allocation for SAP-based egress queuing. If port-based
queuing is disabled, then users must allocate resources for SAP-based egress queuing using
this command. If no resources are allocated, SAPs cannot be created.
When port-based queuing is enabled, resources can be taken away from SAP-based egress
queues and allocated to other features that share the ingress-internal-tcam pool (for
example, SAP ingress qos and Ingress ACLs).
The no form of this command reverts to the default value.
7210 SAS-T Access-uplink mode (per
node)
07 4
7210 SAS-T Network Mode (per node) 0 6 3
7210 SAS-R6 (per IMMv1) 0 7 3
7210 SAS-R6 and 7210 SAS-R12 (per
IMMv2)
012 5
7210 SAS-R6 and 7210 SAS-R12 (per
IMM-c)
010 4
7210 SAS-Mxp (per node) 0 10 5
7210 SAS-Sx 1/10GE (per node)
(standalone)
07 4
7210 SAS-Sx 1/10GE (standalone-VC) 0 6 4
7210 SAS-S 1/10GE (per node)
(standalone)
07 4
7210 SAS-S 1/10GE (standalone-VC) 0 6 4
7210 SAS-Sx 10/100GE (per node) 0 3 3
Table 61 Number of Resources Available for QoS-SAP-Ingress-Resource
Platforms Min value
(per node)
Max value (per
node)
Default
Values