7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 569
The mandatory QoS configurations required to achieve higher SAP and service scaling are
as follows.
• Access port-based egress queuing and shaping must be configured on all ports,
including service delivery ports and uplinks.
• Access port-based ingress classification and policing can be configured on uplinks for
higher SAP scaling.
• On the 7210 SAS-Mxp, Epipe and VPLS SAPs must use ingress table-based
classification and policing on service delivery ports for higher SAP scaling. The
7210 SAS-R6 and 7210 SAS-R12 do not support table-based service meters for SAP
ingress policing.
• IES and VPRN SAPs can use table-based classification.
• RVPLS SAPs must use CAM-based classification and policing.
The no form of this command disables the use of high SAP and service scaling for Epipe and
VPLS services.
Default no sap-scale-mode
Parameters mode — Specifies the SAP scale mode.
Values high, low
high — Keyword to enable higher SAP and service scaling.
low — Keyword to disable higher SAP and service scaling.
6.12.2.1.19 Global System Resource Profile Commands
global-res-profile
Syntax global-res-profile
Context config>system
Supported
Platforms
7210 SAS-R6, 7210 SAS-R12, and 7210 SAS-Sx/S 1/10GE: standalone
Description This command enables the context to configure the CAM resources.
Note: Refer to the 7210 SAS-M, T, Mxp, Sx, S Services Guide and 7210 SAS-R6, R12
Services Guide for more information about high SAP scale mode and low SAP scale mode.
To Next Page
Loading...
