Replace a G-240W-J indoor ONT 7368 ISAM ONT G-240W-J Product Guide
74 3FE-48009-AAAA-TCZZA Issue: 01
Note — A new SLID or the old SLID may be used with the replacement
ONT. If a new SLID is used, the new SLID must also be programmed at the
P-OLT using TL1 or a network manager. If the old SLID is used, no changes
need to be made at the P-OLT; see the operations and maintenance documentation
for the OLT for more details.
17 Verify the ONT LEDs, voltage status, and optical signal levels; see the 7368 Hardware and
Cabling Installation Guide.
18 Activate and test the services; see the 7368 Hardware and Cabling Installation Guide.
19 If necessary, reset the ONT.
i Locate the Reset button; see Figure 17.
ii Insert the end of a straightened paper clip or other narrow object into the hole in the
Reset button to reset the ONT.
20 STOP. This procedure is complete.
To Next Page
Loading...
