System Management Guide Security
Edition: 01 3HE 11018 AAAC TQZZA 151
3.10.2.1.13 Keychain Authentication Commands
keychain
Syntax [no] keychain keychain-name
Context config>system>security
Description This command enables the context to configure keychain parameters that are used to
authenticate protocol communications. A keychain must be configured on the system before
it can be applied to a protocol session.
The keychain must include at least one key entry to be valid.
The no form of the command removes the keychain and all commands configured in the
keychain context. If the keychain is associated with a protocol when the no keychain
command is entered, the command will be rejected and an error indicating that the keychain
is in use will be displayed.
Default n/a
Parameters keychain-name — the keychain name, up to 32 characters
direction
Syntax direction
Context config>system>security>keychain
Description This command specifies the stream direction on which the keys will be applied.
Default n/a
bi
Syntax bi
Context config>system>security>keychain>direction
Description This command configures keys for both send and receive stream directions.
Default n/a
To Next Page
Loading...
