Nokia 7705 - Page 166

Security
166
System Management Guide
3HE 11018 AAAC TQZZA Edition: 01
authentication
Syntax authentication [statistics]
Context show>system>security
Description This command displays system login authentication configuration and statistics.
Parameters statistics — appends login and accounting statistics to the display
Output The following output is an example of system security authentication information, and
Table 11 describes the fields.
Output Example
A:ALU-4# show system security authentication
===============================================================================
Authentication sequence : radius tacplus local
===============================================================================
type status timeout retry
server address (secs) count
-------------------------------------------------------------------------------
radius
10.10.10.103 up 5 5
radius
10.10.0.1 up 5 5
radius
10.10.0.2 up 5 5
tacplus
10.10.0.9(49) down 5 n/a
-------------------------------------------------------------------------------
radius admin status : up
tacplus admin status : down
health check : enabled (interval 30)
-------------------------------------------------------------------------------
No. of Servers: 4
===============================================================================
A:ALU-4#
A:ALU-7>show>system>security# authentication statistics
===============================================================================
Authentication sequence : radius tacplus local
===============================================================================
Read view Specifies the variable of the view to read the MIB objects
Write view Specifies the variable of the view to configure the contents of the
agent
Notify view Specifies the variable of the view to send a trap about MIB objects
Table 10 Show System Security Access Group Output Fields (Continued)
Label Description