Nokia 7705 - Page 212

SNMP
212
System Management Guide
3HE 11018 AAAC TQZZA Edition: 01
4.8.2.1.1 SNMP System Commands
snmp
Syntax snmp
Context config>system
Description This command enables the context to configure SNMP parameters.
engineID
Syntax [no] engineID engine-id
Context config>system>snmp
Description This command sets the SNMP engine ID to uniquely identify the SNMPv3 node. By default,
the engine ID is generated using information from the system backplane.
If the SNMP engine ID is changed in the config>system>snmp>engineID engine-id
context, the current configuration must be saved and a reboot must be executed. If the
configuration is not saved and the system is not rebooted, the previously configured SNMP
communities and logger trap-destination notify communities will not be valid for the new
engine ID.
This command could be used, for example, when a chassis is replaced. Use the engine ID of
the first system and configure it in the new system to preserve SNMPv3 security keys. This
allows management stations to use their existing authentication keys for the new system.
Ensure that the engine IDs are not used on multiple systems. A management domain can
only have one instance of each engine ID.
The no form of the command reverts to the default setting.
Default the engine ID is system-generated
Parameters engine-id — an identifier from 10 to 64 hexadecimal digits (5 to 32 octet number),
uniquely identifying this SNMPv3 node. This string is used to access this node from
a remote host with SNMPv3.
Caution: In conformance with IETF standard RFC 3414, User-based Security Model (USM)
for version 3 of the Simple Network Management Protocol (SNMPv3), hashing algorithms
that generate SNMPv3 MD5 or SHA security digest keys use the engine ID. Changing the
SNMP engine ID invalidates all SNMPv3 MD5 and SHA security digest keys and may
render the node unmanageable. If the SNMP engine ID is changed, the SNMP hash keys
must be reconfigured.