System Management Guide SNMP
Edition: 01 3HE 11018 AAAC TQZZA 213
general-port
Syntax general-port port-number
no general-port
Context config>system>snmp
Description This command configures the port number used by this node to receive SNMP request
messages and to send replies. SNMP notifications generated by the agent are sent from the
port specified in the config>log>snmp-trap-group>trap-target command.
The no form of the command reverts to the default value.
Default 161
Parameters port-number — the port number used to send SNMP traffic other than traps
Values 1 to 65535 (decimal)
packet-size
Syntax packet-size bytes
no packet-size
Context config>system>snmp
Description This command configures the maximum SNMP packet size generated by this node. If the
packet size exceeds the MTU size of the egress interface, the packet will be fragmented.
The no form of the command reverts to the default value.
Default 1500 bytes
Parameters bytes — the SNMP packet size in bytes
Values 484 to 9216
shutdown
Syntax [no] shutdown
Context config>system>snmp
Description This command administratively disables SNMP agent operations. System management can
then only be performed using the CLI. Shutting down SNMP does not remove or change
configuration parameters other than the administrative state. This command does not prevent
the agent from sending SNMP notifications to any configured SNMP trap destinations. SNMP
trap destinations are configured under the config>log>snmp-trap-group context.
To Next Page
Loading...
