Nokia 7705 - Page 314

Event and Accounting Logs
314
System Management Guide
3HE 11018 AAAC TQZZA Edition: 01
5.12.2.1.6 Syslog Commands
syslog
Syntax [no] syslog syslog-id
Context config>log
Description This command enables the context to configure a syslog target host that is capable of
receiving selected syslog messages from the 7705 SAR.
A valid syslog-id must have the target syslog host address configured.
A maximum of 10 syslog IDs can be configured.
No log events are sent to a syslog target address until the syslog-id has been configured as
the log destination (to) in the log-id node.
Default No syslog IDs are defined.
Parameters syslog-id — the syslog ID number for the syslog destination, expressed as a decimal
integer
Values 1 to 10
address
Syntax address ip-address
no address
Context config>log>syslog
Description This command associates the syslog target host IP address with the syslog ID.
This parameter is mandatory. If no address is configured, syslog data cannot be forwarded
to the syslog target host.
Only one address can be associated with a syslog-id. If multiple addresses are entered, the
last address entered overwrites the previous address.
The same syslog target host can be used by multiple log IDs.
The no form of the command removes the syslog target host IP address.
Default no address