Event and Accounting Logs
320
System Management Guide
3HE 11018 AAAC TQZZA Edition: 01
Default no from
Parameters main — instructs all events in the main event stream to be sent to the destination defined
in the to command for this destination log-id. The main event stream contains the
events that are not explicitly directed to any other event stream. To limit the events
forwarded to the destination, configure filters using the filter (log destination)
command.
security — instructs all events in the security event stream to be sent to the destination
defined in the to command for this destination log-id. The security stream contains
all events that affect attempts to breach system security such as failed login attempts,
attempts to access MIB tables to which the user is not granted access, or attempts
to enter a branch of the CLI to which access has not been granted. To limit the events
forwarded to the destination, configure filters using the filter (log destination)
command.
change — instructs all events in the user activity stream to be sent to the destination
configured in the to command for this destination log-id. The change event stream
contains all events that directly affect the configuration or operation of this node. To
limit the events forwarded to the change stream destination, configure filters using
the filter (log destination) command.
debug-trace — instructs all debug-trace messages in the debug stream to be sent to the
destination configured in the to command for this destination log-id. Filters applied to
debug messages are limited to application and subject.
to console
Syntax to console
Context config>log>log-id
Description This command instructs the events selected for the log ID to be directed to the console. If the
console is not connected, all entries are dropped.
The command is one of the to commands used to specify the log ID destination. A to
command is mandatory when configuring a log destination.
The source of the data stream must be specified in the from command prior to configuring
the destination with the to command.
The to command can only be set once. It cannot be modified or re-entered. If the log
destination needs to be changed or if the maximum size of an SNMP log or memory log needs
to be modified, the log ID must be removed and then recreated.
Default No destination is specified
To Next Page
Loading...
