System Management Guide Event and Accounting Logs
Edition: 01 3HE 11018 AAAC TQZZA 321
to file
Syntax to file log-file-id
Context config>log>log-id
Description This command instructs the events selected for the log ID to be directed to a specified file.
The command is one of the to commands used to specify the log ID destination. A to
command is mandatory when configuring a log destination.
The source of the data stream must be specified in the from command prior to configuring
the destination with the to command.
The to command can only be set once. It cannot be modified or re-entered. If the log
destination needs to be changed or if the maximum size of an SNMP log or memory log needs
to be modified, the log ID must be removed and then recreated.
Default No destination is specified
Parameters log-file-id — instructs the events selected for the log ID to be directed to the log-file-id.
The characteristics of the log-file-id referenced here must have already been defined
in the config>log>file-id log-file-id context.
Values 1 to 99
to memory
Syntax to memory [size]
Context config>log>log-id
Description This command instructs the events selected for the log ID to be directed to a memory file. A
memory file is a circular buffer. Once the file is full, each new entry replaces the oldest entry
in the log.
The command is one of the to commands used to specify the log ID destination. A to
command is mandatory when configuring a log destination.
The source of the data stream must be specified in the from command prior to configuring
the destination with the to command.
The to command can only be set once. It cannot be modified or re-entered. If the log
destination needs to be changed or if the maximum size of an SNMP log or memory log needs
to be modified, the log ID must be removed and then recreated.
Default No destination is specified
To Next Page
Loading...
