After Sales
Technical Documentation
RAE/RAK–1N
Service Software
Page 7– 16
Amendment 1 04/97
1 – PC Setup
When Save Current Setup is selected the program asks for a setup file
name. The saved information will include all parameters shown below:
• Command line parameter value for COM–port selection
– RF Controls menu
• All selections
– Call Simulation
• All selections which are not the same as in the RF Controls menu
– Tuning parameters (PC default values; no effect on EEPROM
values)
• TX power coefficients
• Power connection diagram
– Run MCU Self–tests
• All selections
The following selections are not saved
to the setup file:
– Values which are asked from MS
• AFC value
– Main Menu
• Phone Mode (Start value = Normal)
– PC Setup menu
• Default name for setup file
(Start value = RAE_1.CON)
– Internal audio loop:
To Next Page
Loading...