After Sales
Technical Documentation
RAE/RAK–1N
Service Software
Page 7– 59
Amendment 1 04/97
7 – Complete Test
This menu provides functions to perform various test with default
parameters automatically. Any of 9 different tests maybe included or
excluded to the test series. Choosing the ’Start Testing’ starts the
automatic test sequence.
7.1 – Memory Test
Enabling this choice adds the memory test to be included to the test
sequence. The test is performed with default parameters.
The default parameters used:
Test type default: chessboard
Start address default: 000000h
End address default: 0AFFFFh
The output from the target shows the following:
whether the command was parsed succesfully
whether the test was succesful
7.2 – Get POST Code
Enabling this choice adds the POST code read to be included to the test
sequence. The test is performed with default parameters.
The default parameters used: none
The output from the target shows the following:
whether the command was parsed successfully
whether the test was successful
To Next Page
Loading...