After Sales
Technical Documentation
RAE/RAK–1N
Service Software
Page 7– 62
Amendment 1 04/97
7.9 – Checksum ROM
Enabling this choice adds the Checksum ROM test to be included to the
test sequence. The test is performed with default parameters as follows:
Start Physical Address default:3C00000h
Start Relative Address default: 000000h
End Physical Address default:3E00000h
End Relative Address default: 1FFBFFh
The output from the target shows the following:
whether the command was parsed successfully
whether the test was successful
7.10 – Start Testing
Choosing this choice, the automatic test sequence is started using the
enabled tests. These tests can be carried out individually by disabling all
tests except the one required and then selecting ‘Start Testing.’
The output from the target shows the following:
whether the tests are O.K. or have failed.
To Next Page
Loading...