PC connector
LAN
connector
Handset connector
Alphabetic keyboard connector
USB connectors
Headset jack
Additional key module
connector
Power connector
Figure 8.2: 8082 My IC Phone set connectors
8.1.2.1.2 Commissioning the set
This section describes how to commission the set in the two available initialization options:
• Static initialization: commissioning is manual on the set and through OMC
• Dynamic initialization (DHCP): no commissioning is needed, 8082 My IC Phone sets are fully plug &
phone
Depending on the selected mode, the set commissioning is different.
For static initialization, the operation order is as follows:
1. Connect the set, refer to Connecting the set on page 114
2. Configure network parameters on the set, refer to Configuring network parameters for static
initialization on page 116
For dynamic initialization, the operation order is as follows:
1. Configure OXO Connect DHCP server, refer to Configuring OXO Connect DHCP server on page
115, or configure an external DHCP server, refer to Configuring an external DHCP server for
dynamic initialization on page 115
2. Connect the set, refer to Connecting the set on page 114
3. If necessary, configure the user name and password in OMC, refer to Configuring the user name
and password in OMC on page 116
8.1.2.1.2.1 Prerequisites
• The OXO Connect must be operational
Chapter
8
Device commissioning
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual 113/216
To Next Page
Loading...