8.4.1 Connecting the set
To connect the set to the LAN:
• If the set is powered by PoE:
1. Turn the set over
2. Plug the RJ9 cable into the set LAN connector
3. Connect the RJ9 cable to the LAN itself via a PoE hub/switch
• If the set is not powered by PoE, plug the AC/DC external adapter to the set power supply
connector and connect the plug to the power supply
Power adapter
connector (DSCV)
Power over Ethernet (PoE)
connector (LAN)
8.4.2 Configuring IP parameters
To configure IP settings:
1. From the local menu, go to the Android settings
2. Select Wireless and networks > Network > NOE
3. Enter the following parameters:
• IP Parameters
• IP Address
• IP Mask
• Router address
• NOE
• TFTP server IP address
8.4.3 Initialization
Initialization for 8088 Smart DeskPhone is the same as for 80x8s Premium DeskPhone sets (see Set
initialization on page 135).
8088 Smart DeskPhone sets initialize in dynamic mode and retrieve IP information automatically.
8.4.4 Binary file download
The 8088 Smart DeskPhone set requires binary files, automatically downloaded at set intialization.
The 8088 Smart DeskPhone application binary is downloaded in background. When the download is
completed and the phone is in idle state, the upgrade starts. While downloading the new firmware, the
phone runs with the current firmware.
Chapter
8
Device commissioning
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual 137/216
To Next Page
Loading...