ISDN ACCESS - E1
BUSY RAI AIS
NOS CRC LOS
PRA-T2
PBXNETW
2.4.2.7.1 Function of the LEDs
T2 Name T1 Name Function
BUSY BUSY B-channels busy (red LED lights up if at least 1 B-channel is busy)
RAI (ATD) RAI Remote frame alarm (red LED lights up on alarm)
AIS (SIA2M) AIS Too many "1's in the 2-Mbit binary train (red LED lights up on alarm)
NOS (MS) NSIG Absence of 2-Mbit signal (red LED lights up on alarm)
CRC (TE) CRC CRC error (red LED lights up on alarm)
LOS (PVT) NSYN Loss of frame alignment (red LED lights up on alarm)
2.4.2.8 APA Boards
This board is used to connect to the analog public network (2, 4 or 8 LR).
1
2
3
4
"Analog Public Access".
APA8
5
6
7
8
The APA board does not support pulse dialing in Australia and New Zealand.
2.4.2.9 LanX-2 Boards
The LanX8-2 and LanX16-2 are second generation boards integrating respectively 1 or 2 Ethernet
Gigabit ports for a Lanswitch/Layer 2 configuration. Any port can be used as an Uplink, as all the ports
are auto MDI/MDIX.
Unlike the 1st generation boards, the LEDs of the A and B ports are both located at the top of the
board. The Led display is as follows:
• Green LED (left) = link status and activity:
• off: link disconnected
• on: link connected
• blinking: link active
• yellow LED (right) = speed:
Chapter
2
Hardware description
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual 30/216
To Next Page
Loading...