Nokia Alcatel-Lucent OXO Connect Series - 8.7.2.2 Jumpers; 8.7.3 External connections; 8.7.3.1 V24;CTI Interface Module Connection

To Next Page

To Previous Page

8.7.2.2 Jumpers

The jumper in a gray background is factory installed.

Operation Mode

Stand AloneAssociated UA Set

To configure the V24/CTI Interface Module, open the device with the 2 screws located under the

module.

If the jumper is positioned for "stand-alone" operation, an associated set cannot work.

If the jumper is positioned for "associated UA set" operation, the associated set is mandatory, the

Interface Module cannot work without it.

8.7.3 External connections

8.7.3.1 V24/CTI Interface Module Connection

The V24/CTI Interface Module is connected as follows:

Chapter

Device commissioning

8AL91217USAA - Ed. 01 - July 2018 - Installation Manual 143/216