Nokia Alcatel-Lucent OXO Connect Series - 8.1.2.1.4.2 Enabling video support for a 8082 My IC Phone set; 8.1.2.1.5 SIP door phone parameters

OMC Parameter Common/Specific
to 8082 My IC
phones
Default Value Possible Values
Video Encoding Profile Medium Common 1000 kbps [0 .. 65535]
Video Encoding Profile High Common 2500 kbps [0 .. 65535]
Video Call Packetization Mode Common PM0 PM0 / PM1 / NS
8.1.2.1.4.2 Enabling video support for a 8082 My IC Phone set
The Video Support feature right is specific to each 8082 My IC Phone set. Video telephony is enabled
or disabled specifically for each set.
Note:
Enabling is mandatory to support Video calls (incoming or outgoing) for 8082 My IC Phone sets.
To enable/disable “Video Support”:
OMC -> User/Base stations List -> 8082 MY IC Phone-> Details-> Features -> Feature Rights ->
Part 1
Video support: select the check box to allow video support on the 8082 My IC Phone.
8.1.2.1.5 SIP door phone parameters
Note:
If SIP door phone management is to be done with video support, refer to Video call parameters on page 119 to
enable video.
The generic parameters for SIP door phone management with 8082 My IC Phone can be modified from
OMC:
• As of OXO Connect R2.1:
Subscribers Misc > Generic Parameters for SIP Phones > Door Phone Parameters
• As of OXO Connect R3.0:
System Miscellaneous > Generic Parameters for IP Phones > Door Phone Parameters
OMC Parameter Common/Specific to
8082 My IC phones
Default Value Possible Values
Door Phone Name Common Doorcam STRING
Door Open Signal Common 55 STRING
Door Phone Name: defines the name that must be given for all SIP door phone terminals. Default
value for this parameter is 'Doorcam'.
The unique name defined with ‘Door Phone Name’ parameter is used by 8082 My IC Phone to identify
calls from SIP door phones.
Note:
The 'Door Phone Name’ parameter is case sensitive. SIP door phone names must be unique and not the same as
the ‘Door Phone Name’ parameter.
Door Open Signal: defines the DTMF code that is sent from 8082 My IC Phone to SIP door phone to
open the door latch. The default value for this parameter is 55.
Chapter
8
Device commissioning
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual 121/216