4. Set the Reset to factory option to Yes
Your are prompted to enter the administrator password required for the reset to factory.
The default administrator password is *tx8000#.
5. Enter the administrator password, then press OK to confirm the reset to factory, or press Cancel to
cancel the reset.
• If the password is WRONG or Cancel is pressed; the set displays again the reset screen, the
choice selector is set to NO: without further action, the set will go on with normal startup.
• If the password is VALID, you are prompted to confirm the action:
6. Press Yes to confirm the reset to factory: reset to factory is performed and the set restarts
immediately.
Chapter
8
Device commissioning
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual 123/216
To Next Page
Loading...