Tools
100
Copyright © 2007 Nokia. All rights reserved.
To be able to use a data connection, the network service
provider must support this feature, and if necessary,
activate it for your SIM card.
Packet data
Follow the instructions from your service provider.
Access point name—You obtain the access point name
from your network operator or service provider.
User name—The user name may be needed to make a data
connection, and is usually provided by the service
provider.
Prompt password—If you must enter the password every
time you log in to a server, or if you do not want to save
your password in the device, select Yes.
Password—A password may be needed to make a data
connection, and is usually provided by the service
provider.
Authentication—Select Normal or Secure.
Homepage—Depending on the access point you are
setting up, enter the Web address or the address of the
multimedia messaging center.
Select Options > Advanced settings to change the
following settings:
Network type—Select the Internet protocol type to use:
IPv4 settings or IPv6 settings. The other settings depend
on the selected network type.
Phone IP address (for IPv4 only)—Enter the IP address of
your device.
DNS address—In Primary name serv.:, enter the IP address
of the primary DNS server. In Second. name server:,
enter the IP address of the secondary DNS server.
Contact your Internet service provider to obtain
these addresses.
Proxy serv. address—Define the address for the proxy
server.
Proxy port number—Enter the proxy port number.
Wireless LAN
Follow the instructions from your service provider.
WLAN netw. name—Select Enter manually or Search for
netw.. If you select an existing network, WLAN netw.
mode and WLAN security mode are determined by the
settings of its access point device.
Network status—Select whether the network name is
shown.
WLAN netw. mode—Select Ad-hoc to create an ad hoc
network and to allow devices to send and receive data
directly; a wireless LAN access point device is not needed.
9253189_N80_en_apac.book Page 100 Tuesday, September 25, 2007 10:09 AM
To Next Page
Loading...
