Tools
107
Copyright © 2007 Nokia. All rights reserved.
Cell info display—Select On to set the device to indicate
when it is used in a cellular network based on microcellular
network (MCN) technology and to activate cell info
reception.
Enhancement
In the standby mode, indicates a compatible headset
is connected, and that the headset is unavailable, or a
Bluetooth connection connectivity to a headset is lost.
indicates a compatible loopset is connected and that
a Text phone is connected.
Select Headset, Loopset, Text phone, Bluetooth
handsfree, or Music stand and from the following:
Default profile—Set the profile that you want activated
each time you connect a certain compatible enhancement
to your device. See “Profiles—set tones”, p. 93.
Automatic answer—Set if you want the device to answer
an incoming call automatically after 5 seconds. If the
ringing type is set to Beep once or Silent, automatic
answer is disabled. Automatic answer is not available for
Text phone.
Lights—Set whether lights remain on, or are switched off
after the time-out. This setting is not available for all
enhancements.
If you are using a Text phone, you must activate it on your
device. Press , and select Tools > Settings >
Enhancement > Text phone > Use text phone > Yes.
Voice commands
You can use voice commands to control your device.
For more information about the enhanced voice
commands supported by your device, see “Voice dialing”,
p. 57.
To activate enhanced voice commands for starting
applications and profiles, you must open the Voice cm.
application and its Profiles folder. Press , and select
Tools > Voice cm. > Profiles; the device creates voice
tags for the applications and profiles. To use enhanced
voice commands, press and hold in the standby mode,
and say a voice command. The voice command is the name
of the application or profile displayed in the list.
To add more applications to the list, select Options > New
application. To add a second voice command that can be
used to start the application, select Options > Change
command, and enter the new voice command as text.
Avoid very short names, abbreviations, and acronyms.
To listen to the synthesized voice tag, select Options >
Playback.
9253189_N80_en_apac.book Page 107 Tuesday, September 25, 2007 10:09 AM
To Next Page
Loading...
