Nokia N80 - Answer or Reject a Video Call; Options During a Voice Call

Make calls
62
Copyright © 2007 Nokia. All rights reserved.
edit the text before sending it. To set up this option and
write a standard text message, see “Call settings”, p. 98.
Answer or reject a video call
When a video call arrives, is displayed.
Tip! You can assign a ringing tone for video calls.
Press and select Profiles.
Press to answer the video call. Allow video image to
be sent to caller? appears on the display. To start sending
live video image, select Yes.
If you do not activate the video call, video sending is not
activated, and you only hear the voice of the caller. A grey
screen is shown in place of the video image. To replace the
grey screen with a still image captured by the camera in
your device, see “Call settings”, Image in video call,
p. 98.
To end the video call, press .
Call waiting (network service)
You can answer a call while you have another call in
progress if you have activated Call waiting in Tools >
Settings > Call > Call waiting.
Tip! To change the device tones for different
environments and events, for example, when you
want your device to be silent, see “Profiles—set
tones”, p. 93.
To answer the waiting call, press . The first call is put
on hold.
To switch between the two calls, select Swap. To connect
an incoming call or a call on hold with an active call and
to disconnect yourself from the calls, select Options >
Transfer. To end the active call, press or close the
sliding keypad; the first call is still active. To end both calls,
select Options > End all calls.
Options during a voice call
Many of the options that you can use during a voice call
are network services. Select Options during a call for some
of the following options: Mute or Unmute, Answer,
Reject, Swap, Hold or Unhold, Activate handset, Activate
loudsp., or Activate handsfree (if a compatible headset
with Bluetooth connectivity is attached), End active call
or End all calls, New call, Conference, Transfer, and Open
active standby. Select from the following:
Replace—to end an active call and replace it by answering
the waiting call.
Send MMS (in UMTS networks only)—to send an image or
a video in a multimedia message to the other participant
of the call. You can edit the message and change the
9253189_N80_en_apac.book Page 62 Tuesday, September 25, 2007 10:09 AM