Nokia N80 - Page 92

Connectivity
83
Copyright © 2007 Nokia. All rights reserved.
Settings
Press , and select Connect. > Bluetooth. When you
open the application for the first time, you are asked to
define a name for your device. After you set Bluetooth
connectivity on and change My phone's visibility to
Shown to all, your device and this name can be seen by
other users with devices using Bluetooth wireless
technology.
Select from the following:
Bluetooth—Select On or Off. To connect wirelessly to
another compatible device, first set Bluetooth connectivity
On, then establish a connection.
My phone's visibility—To allow your device to be found by
other devices with Bluetooth technology, select Shown to
all. To hide it from other devices, select Hidden.
My phone's name—Edit the name of your device.
Remote SIM mode—To enable another device, such as a
compatible car kit enhancement, to use the SIM card in
your device to connect to the network, select On.
Remote SIM mode
To use the remote SIM mode with a compatible car kit
enhancement, set Bluetooth connectivity on, and enable
the use of the remote SIM mode with your device.
Before the mode can be activated, the two devices must be
paired and the pairing initiated from the other device.
When pairing, use a 16-digit passcode, and set the other
device as authorized. See “Pair devices”, p. 84. Activate the
remote SIM mode from the other device.
When remote SIM mode is on in your Nokia N80, Remote
SIM is displayed in the standby mode. The connection to
the wireless network is turned off, as indicated by in
the signal strength indicator area, and you cannot use SIM
card services or features requiring cellular network
coverage. However, a wireless LAN connection remains
active during the remote SIM mode.
When the wireless device is in the remote SIM mode,
you can only use a compatible connected enhancement,
such as a car kit, to make or receive calls. Your wireless
device will not make any calls, except to the emergency
numbers programmed into your device, while in this mode.
To make calls from your device, you must first leave the
remote SIM mode. If the device has been locked, enter the
lock code to unlock it first.
To leave the remote SIM mode, press the power key,
and select Exit rem. SIM mode.
Security tips
When you are not using Bluetooth connectivity,
select Bluetooth > Off or My phone's visibility >
Hidden.
9253189_N80_en_apac.book Page 83 Tuesday, September 25, 2007 10:09 AM