Nomadic P1000 - Page 16

16
Remote Control - Eective Range
To ensure proper function of the remote control follow the steps below:
1. The remote control must be held at an angle within 30° perpendicular to the projector’s IR remote control sensor(s).
2. The distance between the remote control and the sensor(s) should not exceed 8 m (26 ft.)
Remote Control - Replacing the Batteries
1. Remove the battery cover from the bottom of the remote control by pressing the nger grip and sliding it across.
2. Remove any existing batteries (if necessary) and install two AAA batteries.
3. Observe the battery’s polarities as indicated in the battery compartment.
4. Replace the battery cover by aligning it with the base and pushing it back into position.
NOTE: 
• Avoid leaving the remote control and batteries in excessive heat or a humid environment.
• Replace only with the same or equivalent type recommended by the battery manufacturer.
• If the batteries are drained or if you will not be using the remote control for an extended period of time, remove the batteries to
avoid damage to the remote control.
• A battery subjected to extremely low air pressure may result in an explosion or the leakage of ammable liquid or gas.
• Avoid high or low extreme temperatures that can result in an explosion or the leakage of ammable liquid or gas; that a battery
can be subjected to during use, storage or transportation; and low air pressure at high altitude.
• Dispose of the used batteries according to the manufacturer’s instructions and local environment regulations for your region.
• Disposal of a battery into re or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion.