20
Mounting the Projector
NOTE: If you buy a third-party mount, please use the correct screw size. Screw size may vary depending on the thickness of the
mounting plate.
1. To ensure the most secure installation, please use a qualied wall or ceiling mount kit.
2. Ensure the screw used to attach a mount to the projector meet the following specications:
• Screw type: 1/4UNC
• Maximum Screw length: 8 mm
Tripod hole
NOTE:
• Avoid installing the projector near a heat source.
• Keep at least a 10 cm gap between the wall/ceiling and the bottom of the projector.
To Next Page
Loading...
