MAIN MENU
Navigating past the end of the menu will return the control panel to the Normal
Operating Screen
More ?
Toggle the "AUTO (YES)" switch to edit or view more sensor
settings.
25 29
Displays readings from optional boom sensors (left inner and right
inner).
This menu prompt may not be displayed.
31 31 32
Displays the current boom heights in inches. The heights are adjusted
for the offset between the sensor and nozzles.
If any sensor errors are
detected the type of error will be displayed here.
30 MM 35
SENSOR
DISPLAY Menu
SENSOR DISPLAY /
SETUP (NO) Switch
SETUP Menu
The Normal Operating Screen is normally
displayed. While at other menu prompts, if no
switch has been pressed for 30 seconds, the
control panel will revert to this screen. Also,
from any menu prompt, if you toggle and hold
the "SETUP (NO)" switch for two seconds, the
control panel will return to this screen.
To navigate to the other menu prompts in this
table, toggle the "SENSOR DISPLAY /
SETUP (NO)" switch in the indicated
direction
Sensi 5
A higher number means more control actions and quicker response. A
lower number will tend to stabilize the boom and make it less active.
Soil ON
Or
Crop ON
Use the " +/- " switch to set the sensor target to SOIL or CROP mode.
ReTune?
The ReTune will optimize your system for the best performance
possible.
More ?
Toggle the "AUTO (YES)" switch to edit or view more control
settings
Navigating past the end of the menu will return the control panel to the Normal
Operating Screen
To Previous Page
Loading...
