Norac UC4 - 7 Quick Reference

30
7 QUICK REFERENCE
7.1 ISSUES DURING SYSTEM SETUP
Table 4 – During System Setup (Install or ReTune)
Symptom See
Section
See
Page
 During Control Panel Power Up
Wrong number of sensors shown 4.2.1 10
Number of sensors are "Absent"
4.2.1 10
"Scanning" or ">>>>" stuck on display
4.2.1 10
 During Wiring Test
"Wiring!" Displayed
4.1.3a) b)
,5.1
9, 21
Control panel displayed "OK" but the wrong
boom moved
4.3.3 14
Control panel displayed "OK" but the boom
moved wrong direction
4.3.3 14
Booms do not move 4.3.1, 4.3.7 14, 16
 During Sensor Detect
"SN=0 det" "Retry" displayed
5.1 21
"Too Many" "Retry" displayed
5.1 21
"SNR xxxx" "Retry"
4.2.5 13
Stuck at "Exit Cab" "push"… 4.5.1, 4.5.2,
4.5.3
19, 19
 During Boom Geometry Tuning
Timeout Error at "LftDet" or "RgtDet" 4.3.3 a), b),
4.3.8
14, 17
Timeout Error at "MlfDet" 4.3.3 a), b),
c) , 4.3.8
14, 17
Timeout Error at "MrlDet" 4.3.2a), b),
4.3.8
14, 17
Timeout Error at "DZ Stp 1"
4.3.3 a) 14
Timeout Error at "KP Stp 4"
4.3.3 a) 14
Timeout Error at "Adj 255"
4.3.3 a) 14
Timeout Error at "Adj 4"
4.4 18
"Too High" or "Too Low" message 4.2.3 a),
4.3.3 a-3)
11, 14
"Backwards" "Retry" displayed
5.1 21