NORAM 65ET GRADER
4-49
Lubrication and Maintenance - Grader Components
4
When Required
Battery Cables - Inspect / Replace
1. Place Master Switch (1) in OFF position.
NOTICE: Disconnecting battery too soon will prevent
purging of the DEF lines after engine is shut down. Damage
to the DEF system and emission control system can occur.
• If equipped with a CAT engine, DO NOT turn mas-
ter switch OFF while lamp
(2) is illuminated. Lamp
remains ON approximately 2 minutes after engine
is shut down.
• If equipped with a Cummins engine, DO NOT turn
master switch OFF for approximately 2 minutes
after engine is shut down.
2. Inspect battery cables and connections for cracks or
corrosion.
3. Replace broken terminals, connectors, or cables.
4. Clean corroded connections with a battery brush or a
wire brush until shiny.
5. Remove any and all debris from surrounding
surfaces.
Lights - Replace
Bulbs and sealed beams are replaceable as individual
items.
For brake and turn signal/flasher bulbs, remove screws
(1) to access the bulb. For headlights and work lights,
remove screws
(2) holding the lens covers. The sealed
beams can be unplugged and replacements installed.
Extinguish all smoking materials and open flames when working around
batteries. Battery gas is highly flammable.
Battery posts, terminals and related accessories contain lead compounds,
chemicals known to the state of California to cause cancer and reproductive
harm. Wash hands after handling.
To Next Page
Loading...