1
NORAM 65ET GRADER
2-24
General Information
2
Component Identification and Locations
Articulation Control Lever
Lever (1) pivots the motor grader frame.
Front Wheel Lean Control Lever
Lever (2) controls the angle of the front wheels.
NOTE: Front wheel lean has a lock pin which must
be removed manually to actuate wheel lean.
Implement Control Lever
Lever (3) operates the optional front and rear mounted
implements.
NOTE: Front and rear mounted implements each
have a lock pin which must
be removed manually to
raise and lower the implement, otherwise equipment
damage will result.
NOTE: On machines equipped with front and rear
implements, the lever control changes between front
and rear implements according to the position of the
implement function switch.
Right Side Moldboard Height Control Lever
Lever (4) raises, lowers or floats the right side of the moldboard.
To Next Page
Loading...