NORAM 65ET GRADER
2-35
General Information
2
Electronic Display
AEB Mode Request
The AEB serves to compensate tolerances (plate clearance
and pressure level), which are influencing the filling
procedure of the transmission clutches.
Before activating AEB Mode it is necessary to:
• turn Inching “ON (1)”
• raise transmission temperature to 185° F by placing
transmission in 6th gear, depressing foot brake, and
turning throttle to full
NOTICE: DO NOT let Oil Temperature exceed 187° or Converter Temperature exceed 200°.
NOTE: View Transmission Diagnostic Screen for transmission oil temperature.
• once oil is 185°, apply parking brake
• place transmission in “NEUTRAL”, and ensure engine is idling
Once the required conditions are met, to activate, press the Control Keys associated with the up or
down arrows, followed by the right arrow to select desired setting. Select “AEB MODE REQUEST” to
begin AEB cycle.
Press the Control Key associated with the “ESC” icon to return to the Menu Screen.
AEB Calibration Screen
When AEB Mode Request is active, AEB Calibration
Screen is displayed. AEB Calibration Screen displays:
• AEB Cycle Number
• Transmission Oil Temperature
• Engine Speed
• Output Shaft Speed
• Park Brake
Allow the AEB cycle to complete before disengaging the parking brake. The AEB cycle should take
between 3 – 5 minutes to complete. After calibration is complete, restart machine and operate as
normal.
AEB calibration is only necessary after a Transmission Control Unit (TCU) or transmission repair/
replacement, transmission oil and filter change, or to improve shift quality.
To Next Page
Loading...