NORAM 65ET GRADER
3-23
Operation
3
Moldboard and Implement Operation
Moving a Disabled Machine
Whenever possible, move a disabled machine using a transport trailer. If this is not possible the
motor grader can be towed short distance to a more suitable site for field service.
Towing
NOTICE: DO NOT tow motor grader faster than 5 mph (8 kph). DO NOT tow motor grader farther than 6
miles (10 km).
Attach a tow bar to the front of the motor grader. Never attach chains or ropes to the ROPS to pull. If
chains are used, they must be of sufficient size to handle the load. If possible, operate the engine to
provide steering, braking and lubrication to rotating components.
Hauling
Install frame articulation lock pin and wheel lean lock
pin.
Load machine so all wheels are completely on the trailer.
Position moldboard within width of trailer and lower.
Lock front and rear implements to prevent unintended
lowering.
Securely attach motor grader to trailer using the front
(1)
and rear (2) tie-down locations.
NOTICE: Cover exhaust outlet so wind does not spin
turbocharger and damage bearings.
When hauling or towing motor grader insert wheel lean lock pin and articulation
lock pin.
DO NOT use cables or rope to tow motor grader. If cable or rope breaks or slips,
it may whip with sufficient force to cause serious injury.
When using a chain, attach chain with hook open side facing up so, if the hook
slips, it will drop down instead of flying up.
To Next Page
Loading...