NORAM 65ET GRADER
4-19
Lubrication and Maintenance - Grader Components
4
Every 50 Hours or Weekly
Front Axle Pivot Pins - Grease
One fitting (1) on front axle pivot pin. 2-4 shots.
Steering Cylinder - Grease
One fitting (2) on each end of steering cylinder. 2-4 shots
each.
Front Axle Knuckle Pivot - Grease
One fitting (1) on each of two front axle knuckle pivots.
2-4 shots each.
Front Axle Spindle Pivot - Grease
One fitting (2) on each of two front axle spindle pivots.
2-4 shots each.
Front Wheel Lean Cylinder - Grease
One fitting (3) on each end of wheel lean cylinder.
One fitting
(4) on each end of connecting rod.
2-4 shots each.
Tie Rod Ends - Grease
One fitting (5) on each end of tie rod. 1-2 shots each.
To Next Page
Loading...