NORAM 65ET GRADER
4-20
Every 50 Hours or Weekly
1
4
Lubrication and Maintenance - Grader Components
Moldboard Pitch Adjustment - Grease
One fitting (1) on each end of moldboard pitch cylinder or
optional manual adjuster rod. 2-4 shots each.
Implement Lift Cylinders - Grease
One fitting (1) located on each end of any implement
cylinders installed. 2-4 shots each.
Articulation Joint Bearings - Grease
One fitting is located on the right side of the upper (1)
and lower
(2) articulation joints. 2-4 shots each.
Articulation Cylinders - Grease
One fitting (3) is located at each end of both articulation
cylinders. 2-4 shots each.
To Next Page
Loading...