Norco MITX-6922 - AMT Configuration

MITX-6922 Mini-ITX Motherboard Based on Intel QM67/QM77 Chipset
32
3.2.5 AMT Configuration
BIOS SETUP UTILITY
Intel AMT [Enabled]
Enable ME [Enabled]
BIOS Hotkey Pressed [Disabled]
Un-Configure ME [Disabled]
End of Post Enable [Enabled]
Enable / Disable Intel(R) Active
Management Technology BIOS
Extension.
Note: iAMT H/W is always
enabled.
This option just controls the BIOS
extension execution.
If enabled, this requires additional
firmware in the SPI device.
→←：Select Screen
↑↓：Select Item
Enter：Select
+/-：Change Opt.
F1：General Help
F9：Optimized Defaults
F10：Save & Exit
ESC：Exit
Version 2.10.1208. Copyright（C）2010 American Megatrends，Inc.
Intel AMT
Remote management function settings，Set value：[Enabled for open]，[Disabled for closed].
Enable ME
Whether to open ME setting，Set value：[Enabled for open]，[Disabled for closed].
BIOS Hotkey Pressed
BIOS Hotkey Pressed ，AMT set interface hot key，usually Ctrl + P，at Enable state， each
time you start, you will enter the AMT setting interface.
Un-configure ME
Whether to restore ME setting，Set value：[Enabled for open]，[Disabled for closed].